First init.

M32JM_Pres-Temp_Sensor/M32JM_Pres-Temp_Sensor.ino

@@ -0,0 +1,63 @@
+#include <Wire.h>
+
+
+int M3200address = 0x28;   // 0x28, 0x36 or 0x46, depending on the sensor.
+float maxPressure =100;  // pressure in PSI for this sensor, 100, 250, 500, ... 10k.
+byte status;
+
+
+unsigned long pressureMillis = 0;
+const int pressureTiming = 500; // 500ms every data acquisition
+
+
+void setup (){
+Serial.begin(9600);
+Serial.println("M3200 initializing");
+Wire.begin();
+}
+
+
+void loop(){
+if (millis()-pressureMillis >= pressureTiming){
+  pressureMillis = millis();
+Wire.requestFrom(M3200address,4);   // request 4 bytes
+int n = Wire.available();
+  if( n == 4){
+    status = 0;
+    uint16_t rawP;     // pressure data from sensor
+    uint16_t rawT;     // temperature data from sensor
+    rawP = (uint16_t) Wire.read();    // upper 8 bits
+    rawP <<= 8;
+    rawP |= (uint16_t) Wire.read();    // lower 8 bits
+    rawT = (uint16_t)  Wire.read();    // upper 8 bits
+    rawT <<= 8;
+    rawT |= (uint16_t) Wire.read();   // lower 8 bits
+
+
+    status = rawP >> 14;   // The status is 0, 1, 2 or 3
+    rawP &= 0x3FFF;   // keep 14 bits, remove status bits
+
+
+    rawT >>= 5;     // the lowest 5 bits are not used
+  
+ // The math could be done with integers, but I choose float for now
+    float pressure = ((rawP - 1000.0) / (15000.0 - 1000.0)) * maxPressure;
+    float temperature = ((rawT - 512.0) / (1075.0 - 512.0)) * 55.0;
+
+
+    Serial.print("Status = ");
+    Serial.println(status);
+    Serial.print( "Pressure = ");
+    Serial.println( pressure);
+    Serial.print( "Temperature = ");
+    Serial.println( temperature);
+    Serial.println("-------------------------------------");
+
+
+  }else{
+    Serial.println( "M3200 Pressure Transducer not Detected");
+  }
+}
+
+
+}